Set-Up Menu; Function Setting - JVC DT-V21G11 Manual De Instrucciones

Setting the menu (cont.)

SET-UP MENU

FUNCTION SETTING

Configure the sub menu display, the lighting color of the tally lamp, the size of images, the brightness of the button lamps.
Item
sub menu POSI.
COLOR SYSTEM
COMPONENT PHASE
TALLY SELECT
DIMMER
LCD SAVER
EXECUTE
SETTING 1st START
WORK TIME
CONTRAST
BACKLIGHT
OSD CONT.
SIDE MASK
reset
CANCEL
STATUS
START AFTER
●
How to use the LCD SAVER
1. Set reduced function to perform.
2. Set both time for starting the function and time for letting it work.
3. Activate the STANDBY MODE by EXECUTE.
■ Aborting the ongoing function operation
Operating this apparatus may lead to aborting the OPERATION MODE.
■ Stopping the operation
Executing "CANCEL". Turn off the power.
●
Once operating the function, unless turned off the power or executed "CANCEL", reduced function is automatically performed
every 24 hours.
■ Example of setting up "1st START" and "WORK TIME"
0h 2h 4h
LCD SAVER in
Standby
Time to set in
the 1st START
Timing to run "EXECUTE"
18
Content
Select the contents and displaying position of
The setting values and features are as follows.
LOWER1 : Displays the current setting and adjustment bar at the lower part of the
screen.
UPPER1 : Displays the current setting and adjustment bar at the upper part of the
screen.
LOWER2 : Displays the current setting at the lower part of the screen.
UPPER2 : Displays the current setting at the upper part of the screen.
• The adjustment bar is not displayed for some items.
Select the color system.
• If the picture is unstable with "AUTO," select "NTSC" or "PAL."
Deactivates the function of PHASE adjustment (Picture adjustment knob and "PICTURE SUB
ADJ." in SET-UP MENU) except when an NTSC signal comes in (☞ 3 on page 9, page 19).
Select the color of the tally lamp.
Select the intensity of the button lamps.
Set for reducing the burden on the LCD panel when it is used for a long time.
Activate the function of the LCD SAVER.
Set the Standby time.
Set the time for operating the function.
Set the reduction of the picture contrast.
Set the reduction of the BACKLIGHT brightness.
Set the reduction of the OSD display contrast.
Set use or nonuse of the side panel.
* The "SIDE MASK" function can operate irrespective of running/cancelling the LCD SAVER
function.
Reset the LCD SAVER SETTING configuration to the status when it was initially purchased.
Cancel the LCD SAVER function. ("CANCEL" will not be displayed during the function stop.)
Display the LCD SAVER function status.
Display required time until the LCD SAVER operation starts.
6h 8h 10h 12h
LCD SAVER in
Operation
Time to set in
WORK TIME
" sub menu. "
14h 16h 18h 20h
LCD SAVER in
Standby
22h 24h
Setting value
LOWER1
UPPER1
LOWER2
UPPER2
AUTO, NTSC, PAL
ENABLE, DISABLE
GREEN, RED
NORMAL, DARK
00h-24h
01h-06h
SAVE, NORMAL
SAVE, NORMAL
SAVE, NORMAL
OFF, ON
OFF, READY
**h**min.