Initial Operation; Maintenance And Cleaning (See Figure K) - Bosch GlassVAC Manual Original

Action
Using
Emptying the dirty water tank
Cleaning the machine
Detaching the microfiber cloth
110 mm
Cleaning microfiber cloth
Accessories

Initial Operation

Note: The battery is supplied partially charged. To ensure
capacity of the battery, completely charge the battery using
the battery charger before using your machine for the first
time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
The battery is protected against deep discharging.
When the battery is discharged, the machine will stop.
Troubleshooting
Problem Possible Cause
Machine will not switch Battery discharged
on
Battery too hot/cold
Restricted or no va- Suction head blocked
cuum
Drain plug removed
Machine turns itself off Battery too hot/cold
Suction head blocked
Water leaks from ma- Spray applicator not mounted correctly
chine
Battery will not charge Battery charger not connected correctly
Battery too hot/cold
Streaking on windows Wiper blade damaged
Too much force applied
Too little force applied
Maintenance and Cleaning (see
figure K)
Always clean the product thoroughly after use.
Remove the suction head from the main body and rinse.
Whilst suction head (2) is removed from the machine, fill the
dirty water tank (7) via the suction head aperture to the max
line with clean, warm water. DO NOT fill the dirty water tank
(7) via the drain hole. Shake the machine and pour the water
out via the drain plug(8).
Bosch Power Tools
Battery Charging (see figures A and C)
Figure Page
Note: The micro-USB port (20) for connection of the micro-
H - I 162 - 164
USB cable (17) is in the handle.
I 164
When the battery charge is low, the charger level indicator
J - K 164 - 165
(4) flashes green.
L 166
When the charger level indicator (4) flashes red, the battery
must be charged. Turn the machine off and charge the bat-
tery.
Connect the machine to the charger (18) using the micro-
M 166
USB cable (17) provided. Plug the battery charger (18) into
the socket. The charging process begins.
During the charging procedure, the handle of the machine
warms up. This is normal.
The charger level indicator (4) continuously lights up red
during the charging procedure. When the battery is fully
charged, the charger level indicator (4) continuously lights
up green.
Disconnect the battery charger from the mains supply when
charging process ends.
Observe the notes for disposal.
Maintenance of the suction head
Protect the suction head against damage during storage.
Prevent the wiper blade from touching paper or cardboard,
as this could damage the wiper blades polymer coating.
Spots or lines may be visible on the polymer coating. This is
normal and does not affect the cleaning performance.
Textiles
Microfiber cloths: 67% polyester, 14% polyamide, 19%
polypropylene
Corrective Action
Recharge battery
Allow to cool/warm
Unblock suction head
Replace drain plug
Allow to cool/warm
Unblock suction head
Mount the spray applicator correctly
Check battery charger and USB cable connec-
tions
Allow to cool/warm
Replace wiper blade (accessory)
Apply reduced force
Apply more force
F 016 L81 778 | (03.12.2018)
English | 11