Placement Of The Mounting; Removing The Mounting; Finding The Wall Studs; Plate - Kenmore 79080323310 Instrucciones De Instalación

Installation Instructions
PLACEMENT OF THE MOUNTING PLATE
I-_ REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
[]Remove the installation instructions,use and care,
exhaust adapter, turntable ring, shelf, filters, glass
tray and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
Small Hardware Bag
Filters and Turntable
Ring bel
Adapter
Shelf
; Tray
[] Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
[] Pull the carton up and off the oven.
[] Cut the middle of the outer protective plastic bag to
remove the mounting plate
Screws Screws
_r Mounting Plate '_
[]Remove the screws from each end of the mounting
plate. This plate will be used as the rear wall template
and for mounting. Reinstall the screws into the holes
where they were removed.
I-_ FINDING THE WALL STUDS
[] Find the studs, using one of the following
methods:
A. Stud finder - a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
[] After locating the stud (s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16" (40.6 cm) or 24" (61 cm) from this mark.
[] Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
EN-6