Cabinet; Blower For - Kenmore 79080323310 Instrucciones De Instalación

Installation Instructions
I-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the
TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST
] lace the microwave in its upright position,
with the top of the unit facing up.
Blower Plate
Backof
_-_Microwave
O_
- Blower Motor
Screw
Remove the screw that holds the blower plate
to the microwave. Remove and save the screw
holding the blower motor to the microwave.
Careflflly pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
EndA__End B
Microwave
Roll the blower unit 90 ° so that fan blade
openings are facing out the top of the
microwave.
Before Rotation After Rotation
Backof
Microwave
Microwave
[]Place the blower unit back into the opening.
Backof
Microwave
CAUTION: Do
not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
EN-13