Installation - General Procedure - Samsung DV48H7400E Serie Manual Del Usuario

installing your dryer

INSTALLATION - GENERAL PROCEDURE

For proper installation, we recommend that you hire a qualifi ed installer.
Read these instructions completely before you begin the installation.
To install the dryer, follow these steps:
1. Move your dryer to an appropriate location for installation. Consider installing the dryer and washer side-
by-side so you have easy access to both appliances.
To move the dryer easily, lay two of the carton cushion-tops on the fl oor. Tip your dryer on its side so it
lies across both cushion-tops. Push the dryer so that it is near its fi nal location. Set your dryer upright.
Leave enough room around the dryer so you can attach the duct work, power cord, etc.
2. If you need to change the direction of the door, go to Door Reversal on page 19. When done, return to
Step 3 below.
3. Review the Exhausting section before installing the exhaust system. Install the duct work from your
dryer to the exhaust hood. The crimped end of the duct sections must point away from your dryer. DO
NOT use sheet metal screws when assembling ducting. These joints should be taped. Never use plastic
fl exible exhaust material.
A tip for tight installations: Attach a section of the exhaust system to your dryer before putting it in
place. Use duct tape to secure this section to your dryer, but do not cover the ventilation slots at the
back of the dryer cabinet.
4. If you have an electric model, skip to Step 6. If you have a gas model, go to the next step.
5. Review the Gas Requirements section, then follow the lettered steps below.
a. Remove the pipe thread protective cap.
b. Apply pipe joint compound or about 1 1/2 wraps of Tefl on tape over all threaded connections.
The pipe joint compound must be resistant to the action of any liquefi ed petroleum gas.
c. Connect the gas supply to your dryer. An additional fi tting is required to connect the 3/4" (1.9 cm)
female thread end of a fl exible connector to the 3/8" (1 cm) male threaded end on the dryer.
d. Securely tighten the gas line fi tting over the threads.
e. Turn on the gas supply. Check all gas connections for leaks using a soap solution. If bubbles
appear, tighten the connections and recheck. DO NOT use an open fl ame to check for gas leaks.
f. Go to Step 6 on the next page
DV7000HA_DV48H_DC68-03170J-10_EN.indd Sec3:14 DV7000HA_DV48H_DC68-03170J-10_EN.indd Sec3:14
English - 14
5/16/2016 5:05:50 PM 5/16/2016 5:05:50 PM