Maintenance And Inspection - Hitachi SV 12SG Instrucciones De Manejo

English
How to hold the orbital sander
Attaching a Sponge Pad or a Stick-
on pad (optional accessories)
Making a Hole in the Sanding Paper
with the Punch Plate (optional
accessories)
Selecting accessories
SANDING PAD AND SANDING PAPER SELECTION
Type
Perforated felt pad
Perforated magic pad
Perforated stick-on
pad
Perforated round pad

MAINTENANCE AND INSPECTION

1. Empting and cleaning the Dust Bag
If the dust bag contains too much saw dust, dust
collection will be aff ected. Empty the dust bag when it
gets full.
Remove the dust bag, open the fastener, and dispose of
the contents.
2. Inspecting the sanding paper
Since use of worn-out sanding paper will degrade
effi ciency and cause possible damage to the pad,
replace the sanding paper as soon a excessive abrasion
is noted.
3. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
4. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
5. Servicing
Consult an authorized Service Agent in the event of
power tool failure.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
4
5
6
―
Sanding pad
Papar mounting
Spring clip
Presser sensitive
Self adhesive
Self adhesive
How to move the orbital sander
101
For optimum operating effi ciency, alternately move the
sander forward and backward at a constant speed and
102
balance.
After installing new sanding paper
Movement of the sander may tend to become unsteady
102
after new sanding paper has been installed, because of
the new, coarse grain of the paper. This can be avoided
103
by slightly tilting the sander forward or backward during
sanding or polishing. Sander movement will become
steady as the sanding paper surface becomes properly
abraded.
Code No.
310354
310355
311978
310356
GUARANTEE
We guarantee Hitachi power tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the power tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a Hitachi Authorized Service Center.
IMPORTANT
Correct connection of the plug
The wires of the main lead are coloured in accordance with
the following code:
Blue: — Neutral
Brown: — Live
As the colours of the wires in the main lead of this tool may
not correspond with the coloured markings identifying the
terminals in your plug proceed as follows:
The wire coloured blue must be connected to the terminal
marked with the letter N or coloured black. The wire
coloured brown must be connected to the terminal marked
with the letter L or coloured red. Neither core must be
connected to the each terminal.
NOTE:
This requirement is provided according to BRITISH
STANDARD 2769: 1984.
Therefore, the letter code and colour code may not be
applicable to other markets except The United Kingdom.
4
Sanding paper
Grid No. Code No.
AA60 310341
AA100 310342
AA150 310343
AA60 310344
AA100 310345
AA150 310346
AA60 310347
AA80 310348
AA100 310349
AA120 310350
AA150 310351
AA180 310352
AA60 310353