Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF THE LAMP
For the installation, you need a 230 V/750 W R-7-s or 230 V/1000 W R-7-s pole-burner.
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Remove the colour-filter-frame.
Step 2: Unlock the protective grid and open it.
Step 3: Insert the pole-burner into the lamp-socket.
Step 4: Close the protective grid and close the lock.
INSTALLATION
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 1 m.
Fix the mounting-bracket on the housing by screwing the fixation-screws included in the delivery.
Mount the projector with the mounting-bracket to your trussing system using an appropriate clamp.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture.
Adjust the desired inclination-angle via the mounting-bracket and fix the bracket-screws tightly.
This device falls under protection-class I. The electric connection must be carried out by a qualified
employee.
Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
In general, lighting effects should not be connected to dimming-packs.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
Do not operate this device with opened protective grid!
DANGER OF FIRE!
International
L
N
9
Tabla de contenido
