Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Should you have further questions, please contact your dealer.
Replacing the lamp
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one U-shaped flash-tube.
Procedure:
Step 1: Unscrew the protective shield counter clockwise. Leave the security chain intact.
Step 2: Remove the protective shield.
Step 3: Remove the old lamp from the lamp-socket.
Step 4: Insert the new U-shaped flash-tube into the lamp-socket.
Step 5: Replace the protective shield and screw it clockwise back in place
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature t
Maximum housing temperature t
Lamp:
OMNILUX 230V/45W stroboscope lamp U-shape
Please note: Every information is subject to change without prior notice. 04.04.2003 ©
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened protective shield!
230 V/50 Hz
45 W
160 x 160 x 170 mm
0.5 kg
45° C
:
a
(steady state):
80° C
B
Article Number:
14/25
85010145
52201070_V_1_0_4946.DOC
Tabla de contenido
