Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CHECKING MOTOR BRUSHES
The state of wear of brushes should be checked every 300
hours of operation.
New brushes have a length of 25 mm. The minimum length
allowed id 13 mm, beyond which you brushes must be
replaced.
NOTE : We recommend using the original brushes in order
to obtain maximum performance and avoid premature wear
of the strips.
If you should need to loosen/tighten the upper nuts that
secure the power cables, it is advisable to hold the lower
In winter, completely clean the vehicle each time you use
the vehicle to avoid failures or problems.
Park the vehicle on hard, dry ground.
Do not use the vehicle if any of its components are frozen.
If the machine presents faults or malfunctions, remove the
cover, (14) fig. 2, which contains the electrical and electronic
control system. (see fig. 6)
There is a red LED (19) fig 6. located on the surface of the
N° LED
FLASHES
0
4
5
6
7
9
10
12
9. COLD CLIMATE
10. TROUBLESHOOTING
DIAGNOSTICS
DESCRIPTION OF
DEFECT
OK
BATTERY VOLTAGE
TOO HIGH DURING
LOWERING
MOTOR TEMPERATURE
HIGH
ELECTRONIC CONTROL
TEMPERATURE HIGH
INCORRECT SETTINGS
BOARD FAULT
FORWARD / REVERSE
DRIVE SWITCH (7)
FAULT
START UP SEQUENCE
nut firm with a wrench at the same time.
BATTERIES
Gel batteries last longer because they have a
gelatinous electrolyte that allows many more cycles
of charging and discharging. For proper use, it is necessary
to recharge these batteries if they remain unused for a
long time.
Use a heat source, not exceeding 100°, to melt the frozen
parts.
Keep the battery charger plugged into a power outlet
(220 V). It will automatically charge the battery.
electronic control system. This indicates the type of error,
depending on the number of pulses. You will need to count
said pulses and compare them with the attached table:
PROBLEM SOLUTION
PUT ON THE LOWEST GEAR
- CHECK BRUSHES
- COOL MOTOR
STOP TO REDUCE TEMPERATURE
CHECK ELECTONIC SETTINGS
VOLTAGE BELOW 12 VOLTS;
IF PROBLEM PERSIST REPLACE
ELECTONIC CONTROL
CHECK DRIVE SWITCH (7) AND
ELECTRICAL SYSTEM OPERATION
BRING THE LEVER (4) TO MINIMUM
AND TURN THE KEY (11) TO OFF;
THEN PUT BACK TO ON AND RE-START
21
GB
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
Tabla de contenido
