Controls; Safety Regulations - Active ELECTRO POWER TRACK 1460 Manual De Instrucciones

GB
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH
1
1- HOPPER
2- MECHANICAL GEAR CHANGE SELECTION LEVER
3- ELECTRIC MOTOR
4- ACCELERATOR
5- LEVEL LIGHT
6- BATTERY CHARGE LEVEL INDICATOR
7- FORWARD / REVERSE DRIVE SWITCH
8- 24 VOLT AUXILIARY OUTLET
1- Read these instructions carefully and make sure
you understand them before operating the unit.
Follow all warnings and safety instructions. Store this
book for future reference.
2- Use original spare parts only; spare parts produced by
other manufacturers may fit improperly and cause injury.
3- Do not allow other persons, children or pets to
remain within a 5 m radius while using the machine.
4- Do not operate the machine when tired, ill or under the
influence of alcohol or drugs.
5- Use the machine only for tasks set forth in this
manual.
6- Inspect the machine before each use. Make sure that
safety devices are not loose, etc. Replace damaged parts.
7- Before working, get familiar with the machine by
using it on flat, clear areas clear of obstacles.
8- Do not perform any maintenance with the key (11) set
to ON.
9- Do not carry people or animals on the machine or
on the platform.
10- Always drive the vehicle forward. Take precautions
against falls before engaging reverse (backward driving).

3. CONTROLS

3
4
15
11
12
9- ACOUSTIC WARNING SIGNAL
10- DRIVE LEVER
11- BATTERY ON/OFF KEY
12- BATTERY CHARGER INDICATOR
13- BATTERY CHARGER PLUG (to be connected to a 220 volt
outlet)
14- ELECTRICAL BOX COVER
15- STEERING LEVER

4. SAFETY REGULATIONS

Make sure there are no obstructions and ensure maximum
visibility.
11- Carefully start or stop the vehicle on uneven
terrain.
12- Do not change speed or carry out U-turns on slopes or
on uneven terrain.
13- Overloads are dangerous. Load the vehicle in
compliance with maximum load capacity.
14- Do not enter water if the level is greater than 20 cm
15- Do not spray pressurised water on the electric
motor or inside the box containing the electrical
circuitry.
16- Do not carry loads exceeding platform dimensions.
17- Do not stack high loads; doing so not only restricts
the field of vision of the operator, but would make
the centre of gravity too high, compromising vehicle
stability.
18- Operate solely with maximum visibility.
19- The vehicle cannot operate on slopes greater than 20°
20- When going down a slope, engage first gear or
reverse gear, remembering to use the engine brake.
21- Do not drive on slopes where there is a risk of tipping
or falling of the vehicle.
18
FIG. 14
2
5
7 9
6
8
14
13
10