Operating The Cleaner - Polaris 360 Manual Del Propietário

Operating the Cleaner

WARNING
To avoid risk of potentially serious injury, do not swim or use the pool
when the cleaner is submerged or operating.
1
Start the Cleaner
1. Connect hose in the pool at the UWF
2. Submerge the cleaner in the pool, allowing it to sink to the bottom.
3. Turn on the filtration pump and allow it to prime. Cleaner will begin to move.
2
Check for Proper Wheel RPM
Before operating the Polaris
(RPM). For maximum efficiency, the Polaris should operate between 28 and 32
RPM.
1. Mark the single side wheel using using a piece of tape (or a small leaf tucked
into the tire).
2. Turn the pump on, hold the cleaner below the water level and count wheel
revolutions for one minute.
3. Optimum wheel speed should be between 28 and 32 RPM.
Single-wheel Side
Sweep Hose
8
.
®
cleaner, check for proper wheel revolutions per minute
®
mark the single
side wheel
mark the single
(leaf, tape, or
side wheel (tape
or small leaf) marker)
C
28 - 32 RPM
1 min
IMPORTANT
Keep cleaner
submerged for
accurate wheel
speed count.