Preventive Maintenance - Schulz SM1300 Manual De Instrucciones

6. Assembling the wet cutting system
ATTENTION
stray voltage.
• The wet cutting system is used to reduce the dust production in the air, improve the quality of the cut and
increase the life span of the blade.
• Connect the hose (13) to the fl ow control valve (12).
• Connect the hose to the water supply point.
• Align the fl ow control valve set with the hole for the screw on the body of the tool.
• Tighten it fi rmly with the screw.
ATTENTION

9. PREVENTIVE MAINTENANCE

Cleaning:
Before performing any cleaning or maintenance, unplug the tool from the power grid;
After use, clean the tool with a damp cloth (do not pour water on the tool) and store it in a clean, dry place
protected from moisture and dust. Keep your tool out of reach of children and people unfamiliar with the use of
the equipment.
Transportation:
Do not pull or carry the tool by the electric cord or allow its contact with edges, sharp elements, rough surfaces,
oil or chemicals that may damage its fl exible and insulating properties;
Do not move the tool with the trigger locked in the "on" position;
Repairs:
If required to perform any repair or replacement of the electric motor brushes, contact the nearest Schulz assis-
tance. Original parts Schulz must be used. The use of non-original parts results in warranty loss and may cause
damage to the equipment or injury.
Escovas (carvão) do Motor
• Verifi car se o produto apresenta anomalia durante a partida (exceso de faiscamento, não liga), pode ser
infl uenciada pelo desgaste do carvão.
• Para inspecionar use uma chave de fenda para remover as tampas dos porta-escovas (quando acessível) fi gu-
Use the wet cutting system only when the tool is protected by a circuit breaker for
Do not tighten the self tapping screw to avoid damaging the fl ow control valve set.
29