Setting The Clock - Aiwa XR-EM70 Manual De Instrucciones

Power economizing mode
Reduces power consumption with the following operations.
When power economizing mode is set to "ON" or
"AUTO"
•When power shuts off, all indications of the display window
including the clock are turned off.
En
•When power turns on by timer recording (page 17), the
display window brightness is set to "DIMMER 3", all
button lamps go off.
•The display window brightens only when the unit is being
operated. When the unit has not been operated for 8 seconds,
the brightness switches to the level chosen by the "DIM
MODE" setting. (If the brightness is set to
"DIM - OFF", the brightness does not change.)
When power economizing mode is set to "AUTO"
In addition to the above:
•If the tape and CD are stopped and there is no audio input
from any connected external equipment for 10 minutes,
power shuts off. (When listening to the radio, however, power
does not shut off automatically.)
1 Press ECO/DIMMER while the unit is turned on.
"ECO MODE" is displayed.
2 Within 8 seconds, press SET.
The current power economizing mode status is displayed.
If power economizing mode is off : "ECO OFF"
If power economizing mode is auto : "ECO AUTO"
If power economizing mode is on : "ECO ON"
3 Within 8 seconds, press f or g to select
the desired power economizing mode.
4 Within 8 seconds, press SET.
8
Standby power consumption
When power economizing mode is off : 14 W
When power economizing mode is on or auto : 0.7 W
If the clock display flashes when the power
economizing mode is on
The power economizing mode cannot be activated. Reset the
clock.
Dimmer
The display window brightness can be adjusted to the following
four levels: " DIM-OFF ", " DIMMER
" DIMMER 2 ", and " DIMMER 3 ".
" DIM-OFF " is the brightest level.
When " DIMMER 3 " is selected, the display is darkest,
and all button lamps go off.
1 Press ECO/DIMMER twice while the unit is turned
on.
"DIM MODE" is displayed.
2 Within 8 seconds, press SET.
The currently selected brightness is displayed.
3 Within 8 seconds, press f or g to select
the desired brightness.
4 Within 8 seconds, press SET.

Setting the clock

1 Hold down SHIFT and press CLOCK on the remote
control.
When the unit is turned off, you can also press SET.
2 Press f or g to set the time.
Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
units.
If f or g is not pressed within 8 seconds, setting
is canceled.
1 ",
3 Press SET.
The time display stops flashing and the clock starts from
00 seconds.
To display the time while the power is on
Hold down SHIFT and press CLOCK on the remote control.
The time will be displayed for 8 seconds.
To switch to the 24-hour standard
Display the time and press s within 8 seconds.
With each press, the clock alternates between 12- and 24-
hour standard time.
Tip:
In the 12-hour standard, "AM12:00" indicates midnight and
"PM12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Reset the clock.