Reset Password; Safety Precautions - König Electronic SEC-ALARM210 Manual De Uso

System status:
1) Back-up batteries
The control centre offers up to 48 hours battery back-up in case of power failure. The system can
operate without batteries, but it is recommended to install 4 x AAA alkaline batteries. To ensure the
back-up batteries are in good condition, there is a built-in battery monitor in the control centre.
To test the batteries:
Step 1: All batteries should be installed to the control centre and the adapter is plugged in.
Step 2: Remove the adapter from the control centre.
Step 3: Monitor the green power indicator based on the information below and determine the batteries
condition.
Green power indicator > On > Good Condition
Green power indicator > Flashing > Batteries are low, replace batteries
Green power indicator > Off > Batteries are dead, replace batteries

2) Reset password

In case the password is forgotten, you can reset the password back to the factory default value, 1 2 3
4.
To reset the password:
Step 1: Remove adapter and all batteries
Step 2: Press and hold the "Learn Button" and plug the adapter back in (keep pressing the "Learn
Button"). Wait until all 4 zone indicators are on. Release the "Learn Button".
Step 3: Zone 1 indicator begins to flash. It will take 4 hours to complete this restore process.
Step 4: The password is restored when all 4 zone indicators are off.
Do not operate the control centre during the password restore process.

Safety precautions:

Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is
required. Disconnect the product from mains and other
equipment if a problem should occur. Do not expose the
product to water or moisture.
11