Aspect Ratio; Replacing The Bulb Of The Dome Light - Panasonic CY-VH9300U Manual De Instrucciones

E

Aspect Ratio

N
G
L
I
S
H
29
[ASPECT]
72
CY-VH9300U
Press [ASPECT] to change the aspect ratio as
follows.
Default: NORMAL
Mode: 4 types
NORMAL
≥ The conventional display
image has a 4 to 3 ratio
of horizontal to vertical.
≥ In this case, a blank area
remains on the right and
left sides of the display.
FULL
≥ The screen is extended
horizontally as a whole
to the aspect of 16 to 9.
≥ The extension ratio is
the same at any point of
the screen.
ZOOM
≥ The screen is fully
extended at the normal
aspect ratio of 4 to 3.
≥ The top and bottom of
the screen are slightly
cut.
JUST
≥ The screen is extended
horizontally to the aspect
ratio of 16 to 9.
≥ The extension ratio
increases toward the
right and left ends of the
screen.
Note:
≥ In some cases, the picture looks different from
the original one due to your selection of aspect.
≥ This is to remind you that compression or
extension of the screen using the aspect ratio
changing function of this product for commercial
purpose of profi t making or viewing/listening
by the public could infringe on the rights of the
author protected by the copyright law.
≥ If you expand normal picture (4 to 3) by using
"JUST", "ZOOM" or "FULL" aspect to the full of
the screen, you might not see the periphery of
the picture, or you might see a distorted picture.
Therefore, use the "NORMAL" mode to see the
original pictures as the author intended it.

Replacing the Bulb of the Dome Light

A
A A
2
1
3
5
6
Caution:
≥ Have the dome light replaced by a qualifi ed
specialist.
Preparation:
≥ Turn the dome light switch off (page 46) and turn
the unit off.
≥ Open the display unit (page 50).
1 Remove the 2 screws.
2 Place your fi ngers at A (in 2 places) on the panel,
and slowly pull down the panel.
3 Pull out the bulb to be replaced.
≥ Do not turn the bulb but pull it straight out.
4 Push the new bulb into place.
5 Insert the end of the panel, and push it back into
place as shown in the fi gure.
6 Secure the screws.
Caution:
≥ While you are replacing a bulb, be absolutely
sure to keep the dome light switch at OFF.
Otherwise, you may burn yourself.
≥ The bulb is very hot to the touch while it is
lighted and immediately after it has gone
off. Before attempting to replace it, turn the
dome light switch off, wait several minutes
and then check that it cooled off.
≥ Use a bulb with the specifi ed ratings
(12 V/5 W). Do not use any other bulb.
≥ Gripping the bulb with too much force may
break it. Wear fi ngerstalls or use some other
anti-slip method when replacing it.
Note:
≥ Be careful not to scratch the surface of the front
cover when attaching it.
CY-VH9300U
E
N
G
L
I
S
H
30
73