Hitachi G 3613DA Instrucciones De Manejo página 14

English
MOUNTING AND OPERATION
Action
Removing and inserting the battery
Charging
Remaining battery indicator
Fitting and adjusting the wheel guard
Fixing the side handle
Assembling depressed center
wheel*
1
Assembling cutting wheel*
Switch operation
Adjusting the number of revolution*
Grinding angle and grinding method
Detaching the fi lter
Charging a USB device from a
electrical outlet
Charging a USB device and battery
from a electrical outlet
How to recharge USB device
When charging of USB device is
completed
Selecting accessories
Mode
Transmission
Dial Settings
Auto
Figure Page
2
3
4
5
6
7
8
1
9
10
2
11
12
13-a
13-b
14
15
―
Status
1
2
3
4
5
A
*1 WARNING
Before use, be sure to tighten the wheel nut with the
included wrench.
Failure to tighten could result in the wheel nut
loosening when the brake is activated during a stop.
2
NOTE
The wheel washer is specifi cally for this product. Do
2
not use it for any other product.
2
*2 About the mode change function
The unit has "Transmission mode" and "Auto mode".
2
○ With Transmission mode, the grinder's number of
3
revolutions can be set at one of fi ve stages.
When operating in Transmission mode, the set number
3
of revolutions will be maintained regardless of changes
in load.
3 ○ With Auto mode, you can lower noise and vibration by
lowering the maximum number of revolutions while in a
4
no-load state.
While in Auto mode, the number of revolutions will be
4
raised if the load becomes greater during operation.
4
On the other hand, the number of revolutions will
be lowered if the load decreases during operation.
4
(Table 3,)
○ Set the mode and dial according to work application.
5
5
5
5
301
Table 3
Number of Revolutions (min
3000
4750
6500
8250
9500
5500
9500
14
) Use
-1
Grinding stainless steel
Rust or paint removal
Grinding, fi nishing
Rough grinding, cutting
Light work, Standby state
Grinding, cutting