Fault Indication - GERATHERM Duotemp GEF-100 Instrucciones De Servicio

FAULT INDICATION

FAULT OR FAULT DE-
FAULT SCRIPTION
SYMBOL
No display The battery
on the LCD has run out.
panel Incorrect bat-
GB
tery polarity.
Measurement The thermo-
not possible meter is not
(or an abnor- ready.
mal value is
displayed)
An abnormal The probe
temperatu- tip is dirty or
re value is damaged. Did
displayed. you hear the
beep after
pressing the
ON button?
LO or HI The tempera-
symbol is ture measured
displayed is outside the
measuring
range
(0 °C -100 °C
or
32 °F-212°F)
Low:
temperature
too low
High:
temperature
too high
11 - GB
CORRECTIVE
MEASURE
Replace the
battery. Ple-
ase note:
The (+) side
of the battery
must face
upwards.
Wait until the
°C symbol is
displayed.
Clean the
probe tip or
get it repaired.
Wait until
you hear the
beep before
removing the
thermometer
from the ear or
forehead.
Check that the
probe tip is
clean and that
the thermome-
ter is properly
inserted into
the ear or
placed on the
forehead.
The battery
has run out.
symbol is
displayed
The thermo-
meter is not
yet ready for
symbol is measuring.
displayed
The ON but-
ton was not
pressed at the
right time.
The ambient
temperature
is outside
symbol is the operating
displayed temperature
range or is
changing too
fast.
Replace the
battery.
Wait until the
GB
°C symbol is
displayed on
the panel.
Then press
the ON button
as soon as
you begin
measuring.
To ensure
accurate
measurement,
let the ther-
mometer rest
at operating
temperature
for 20 minutes
prior to use.
12 - GB