Idiomas disponibles
Idiomas disponibles
m
CAUTION! RISK OF INJURY! Pay
attention to flying chippings and splinters.
There is the risk of injury.
Keep out of the reach of children. Store the
product out of the reach of children.
Check the product for damage before each
use. Please do not use this device if you find
that it is damaged in any way.
Check that the screws are tight before each
use.
Use the product on a solid, level and intact
surface (e.g. a workbench).
Always disconnect the drill from the power
supply before making adjustments or work
breaks.
The drill stand must be mounted on a
workbench or a stable, tilt-free table, to
ensure a safe work. Use the drill holes
the base plate
.
6
˜ Assembly
Note: You need a 5 mm hexagon key
(provided), two open-ended spanners
(10 mm & 14 mm) and a slot screwdriver
(1.0 x 6.0 mm) for assembly and adjustment.
Connect the pillar
7
plate
and tighen the screw to fix the pillar
6
(see Fig. A).
Then fix the slider
9
Mount the lever arm
(see Fig. B). Tighten the screws and nuts as
tight as possible.
Mount the vise
onto the base plate. To do
13
this connect the screws with the guide slots
in the base plate through the two long
slots
(see Fig. C).
14
Note: The vise can be positioned exactly by
moving the guide slots and long slots.
in
5
to the base
on the pillar.
onto the slider
2
4
˜ Mounting the work piece
Hold the quick-release button
pull the locking device
goes (see Fig. D).
Place the work-piece into the vise
Press the quick-release button and push the
locking device with the clamping jaw
against the work-piece.
Tighten the work-piece by turning the locking
device
clockwise (see Fig. E).
15
˜ Clamping in and adjusting the
drill
Fit the drill with its clamping collar into the
drill holding fixture
(see Fig. F).
Insert a suitable drill bit into the chuck.
Unscrew bolt
(see Fig. G).
12
Move the slider
9
on the pillar
, until the drill nearly touches
7
the work-piece.
Retighten screw securely.
˜ Adjusting the drill depth
Loosen the block
8
slider
(see Fig. H).
9
Loosen the locking screw
the left (see Fig. H).
Make sure that the bolt
doing this and slides down to the lowest
position.
Move the lever arm
the desired drill depth on the drill gauge with
indicator
.
11
Fix the locking screw
right turn (see Fig. I).
Do not overtighten the locking screw
the bolt
is fixed.
1
pressed and
16
back as far as it
15
.
13
17
and tighten securely
3
with the clamped in drill
and slide it up to the
by turning it to
10
will be released
1
down and read off
2
and block
with a
10
8
after
10
GB/MT
15
