Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6
USE
6.1 BEFORE USING THE APPLIANCE
Before turning on the appliance, make sure that the plug attached to the electric cable is connected
to the electric outlet, the water supply tube is connected to the faucet, the faucet is turned on, the
drainage tube has been connected according to the instructions.
Opening of the door
Pull the handle forward. The door should open without effort. If you pull the handle while the dishwasher
is running, a safety mechanism will turn off the appliance.
Adding special dishwasher salt
(only in the salt container version)
• Open the door and take out the lower basket
• Remove the lid of the salt container by turning it an-
ticlockwise
Only during the first time you carry out this
operation: fill about 1/2 litre of water into the salt
container
• Use funnel L to fill the special dishwasher salt into
the container (use about 1.0-1.5 kg of salt).
• Remove possible salt residues from the opening of
the container.
• Put the lid of the container back in its place by turning
it clockwise.
• If you don't use the dishwasher immediately after
filling the salt container, run the programme pre-wash
to rinse away the water and salt particles that spilled
over from the container.
Indication of salt level (IF PRESENT)
The green mark under the cap indicates that there is still enough salt in the container. If the green mark
is no longer visible, the salt container needs to be refilled with special dishwasher salt.
For safety reasons we recommend to refill the container after seven wash cycles – always at
the beginning of a cycle.
Use only special dishwasher salt. Other types of salt (e.g., regular household salt) often contain
substances that do not dissolve completely in water and can therefore obstruct the water softener,
thus making it unusable.
For the washing process it is better to use soft water (with a low calcium content), to avoid calcium
deposits on the dishes and on the inside of the dishwasher.
To find out the degree of hardness of your water contact your town administration or use a commercial
testing kit.
Regulation of the water softener system
(IF INCLUDED)
(control panel version with LEDs)
For this reason, the appliance is equipped with a water softener
(fig. 6) which is automatically regenerated in regular intervals
thanks to the saline solution. The salt consumption for the
regeneration process depends on the hardness/softness of the
local water that is being used.
To guarantee an optimal regeneration of the softener it is
necessary to set device D according to your local hardness
(see table) and to make sure that the salt container is always
filled with special dishwasher salt.
Note: When the adjustment device is in the D1 position the
low salt indicator light is deactivated.
L
D
Position
French degrees
of
˚fH
regulation device
1
<15
2
>15 <25
3
>25 <40
4
>40 <90
>=higher/<=lower
5
6
German degrees
˚dH
<8,4
>8,4 <14
>14 <22,4
>22,4 <50,4
1 2 3 4 5 6 7 8 9 0 1
19
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
GB
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
Tabla de contenido
