NuVinci N170S Manual Del Propietário página 8

g . .
Pull the wheel back in the dropout,
tightening the chain to the desired level.
Pull back on the shift rod
retaining nut, not the shift rod.
h . .
Keeping the wheel centered, tighten the acorn
nut with a 15mm socket and torque wrench to
40Nm (29 ft. lbs.).
Over-tightening may damage parts.
Under-tightening will result in the axle
sliding in the dropouts.
i . .
Still holding the wheel tight, tighten the main
shaft nut with a 21mm crows foot and torque
wrench to 50Nm (37 ft. lbs.).
Reinstalling .the .rear .pulley .housing
NOTE:
been pre-installed on the Cruise-
Controller and rear pulley housing
assembly, follow steps a, b and c.
If not, turn to the CruiseController
Installation section of this manual.
a . .
Rotate the shift rod clockwise with
your fingers until it stops; this is full
overdrive.
Be careful not to bend or
damage the end of the shift rod.
Only use your fingers.
Owner's Manual - December 2008
If the control cables have
© 2008 Fallbrook Technologies Inc.

English