Martin Yale 1217A Instrucciones De Operación página 6

SINGLE FOLD (HALF FOLD) STYLE
In order to do a half fold, the 2
reversed, the paper bounces off of the aluminum deflector instead of entering the slot
on the opposite side.
Once the fold table is reversed the setting on it does not matter. Adjust the 1
table paper stop for proper folding. There's a fold chart on the receiving tray with most
common settings. The settings are only approximate, some adjustment may be
necessary for the best fold quality.
NOTE: DO NOT OVERTIGHTEN THE FOLD TABLE THUMB KNOBS.
DOUBLE FOLD (LETTER FOLD)
In order to do a double fold, the 2
first (See diagram on Page 4) . Adjust both the first and the second fold table
appropriately for proper fold. There's a fold chart on the receiving tray of the machine
with most common settings. The fold table settings are only approximate. Some
readjustment may be necessary for optimum fold quality.
RIGHT ANGLE FOLD
1. Set first fold table for stock (8 _" X 11", 8 _" X 14", 11" X 17") and run through
machine for proper single fold.
2. Readjust the feed guides of the machine so that the folded edge of the stock will
be as close to the black feed wheel as possible.
3. Slighly lower the red wheel to accommodate the thicker material (1/20 turn).
4. Readjust the fold system to accommodate the correct fold.
5. Run a test piece and verify proper feed.
Stapled sets are not recommended on the unit due to damaging the folding rollers over
a period of time. However, these can be ran by stapling each set in both of the upper
corners. The staples should be parallel to the top edge of the sheet. An alternative to
TYPES OF FOLDS
nd
folding table should be reversed (see Page 4). When
nd
folding table should be installed with the open end
STAPLED SETS
Martin Yale Industries, Inc.
251 Wedcor Avenue
Wabash, IN 46992
Info@martinyale com
st
fold
VI