Idiomas disponibles
Idiomas disponibles
SECTION 2
Assembly: WORX Brand Models -
Universal Collection System
If your blower/vac is not a WORX Brand
Model, then please proceed to Section 3.
Align the arrow, on the Collection System
adapter, to the smaller Locking Peg on the
TRIVAC
vacuum outlet. Then slide the
®
Collection System adapater over the aligned
Locking Pegs and turn clockwise to lock,
ensuring they are fully secured. No additional
adapter is needed. (Please refer to step A1).
To remove the Universal Collection System,
simply reverse the installation steps.
SECTION 3
Assembly: Popular Brand Models -
Universal Collection System
Black & Decker
, Poulan Pro
®
Poulan
, Craftsman
®
If your blower/vac will not fit any of the
"Engineered Fit" adapters, then please
proceed to Section 4.
6
Please refer to the Blower/Vac Model
Adapter List in Section 1. Choose the correct
"Engineered Fit" adapter and place it into
the Vacuum Outlet shown in A2. Align the
collection system Hose Inlet with the Locking
Pegs on the adapter as shown in A2. Then
slide the Collection System adapater over
the aligned Locking Pegs and turn clockwise
to lock, ensure they are fully secured (Please
refer to step A2).
To remove the Universal Collection System,
simply reverse the installation steps.
SECTION 4
Assembly: All Brand Models - Universal
Collection System
All Brand Models – Choose the "Universal
Fit" adapter (5) and place it onto the Vacuum
Outlet. Please refer to step B1-B5
1. Place the fabric side of the Universal
Adapter over the Vacuum Outlet and slide it on
as far as possible (B1)
2. Pull to tighten the strap and snap the latch
down (B2)
3. Test that the Universal Adapter will not slide
LEAF PRO™
, Murray
,
®
®
, Ryobi
, and Toro
.
®
®
®
off of the blower/vac outlet
4. If further tightening is needed, then unlatch
the latch button and tighten the strap to
further lock the Universal Adapter. Press the
latch down again and recheck if it will slide
off of the blower/vac outlet (B3). Realign and
repeat these steps if needed.
5. Slide the Collection System adapater over
the aligned Locking Pegs and turn clockwise
to lock, ensure they are fully secured (Please
refer to step B5).
Please note: The Universal Adapter may have
space between the Vacuum Outlet and Adapter
Outlet after installation.
To remove the adapter, simply unlatch and
loosen the strap to remove it from the Vacuum
Outlet (Reverse B4).
SECTION 5
Assembly: Container Installation -
LEAF PRO™ Universal Collection
(See Fig. C, D, E)
SECTION 6
Assembly: Troubleshooting
NOTE: If you are having a hard time keeping
the cover on the trash can, please try the
following: Cut a notch between the handle and
trash can rim to create a grove for the
cover to rest in.
EN
