Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Part : INSTALLATION AND PREPARATIONS FOR USE
3.2. Emptying of the Burned Gases from Environment
The cooking appliances that operate with gas, throw the burned gas wastes out
directly to the outside or through the cooker hoods that are connected to the a
chimney that opens directly to the outisde. If it seems not possible to install a
cooker hood, it is required to set an electric fan on the window or wall that has
access to fresh air. This electric fan must have the capacity to change the air of
the kitchen environment 4-5 times of its own volume of air per hour.
There are some factors that must be paid attention to while installing your
oven. Surely be very careful to while installing your oven. Pay attention to our
below instructions in order to be able to prevent any problems and/or
dangerous situations that may occur later.
Pay attention not to place it near the refrigerator, there must be no flammable
or inflammable materials such as curtain, waterproof cloth, etc. that will begin
to burn quickly. The furniture close to oven must be manufactured resistant to
0
temperatures up to 80 C. The minimum heights from the oven's pan and wall
cupboards and cooker hoods with fan over the oven, are shown as above. Thus,
the cooker hood must be at minimum 650mm height from the cooker pan. If
there is no cooker hood, this height must not be less than 700mm.
3.3. Gas connection
The connection of the appliance should be performed in accordance with local
and international standards and regulations applicable. You can find the
information related to appropriate gas types and appropriate gas injectors on
technical data table. If the pressure of used gas is different than these values
stated of the or not stable in your area, it is required to affix an available
pressure regulator on the gas inlet. It is certainly required to contact to the
authorized service to make these adjusments.
If the gas connection is made by a flexible hose that is fixed on the gas inlet of
appliance, it must be fixed by a pipe collar as well. Connect your appliance with
a short and durable hose that is as close as possible to the gas source. The
hose's permitted maximum lenght is 1.5m. The hose that brings gas to the
appliance must be changed once a year for your security.
The points that must be checked during flexible hose assembly
The hose must be kept clear from areas that may heat up to temperatures in
0
excess of 50 C. The hose must not be ruptured, bent or folded. The hose must
be kept clear of sharp corners, moving things, and should not be defective.
Before assembly, it must be checked whether there is any production defect. As
gas is turned on, all connection parts and hose must be checked with bubbly
8
Tabla de contenido
