Entering Ids / Pin; Editing Values In A Table; Calibration - Mettler Toledo SevenCompact S210 Instrucciones De Manejo

1 Press to move left to highlight number or letter, use
move downwards.
2 Press READ to confirm the entry.
The line where the position of alphanumeric character is being entered blinks.
3 To end and confirm entry, use softkeys to highlight screen key OK, and press READ to save the
ID.
— or —
4 To delete information, use softkeys to highlight
entered character.
— or —
5 Press EXIT to return to the upper level of the menu.
The entries are rejected.
4.8.2 Entering IDs / PIN
The four softkeys and READ key are used for navigating on the keypad and entering the ID/PIN.
Example: WATER
1 If 1 is highlighted, press
Q is highlighted.
2 Press once.
W is highlighted.
3 Press READ to enter W.
4 Repositioning the highlighted bar to A, T, E and R, and press READ to enter each letter of sample
ID in sequence as described in steps 1 - 3.
5 Reposition the highlighted bar to OK, and press READ to save the sample ID.
Note
● Instead of entering an ID with the alphanumeric keypad, one can also use a USB-keyboard or a
USB-barcode scanner. In case a character is entered or scanned that is not present on the instru­
ment keyboard it will display the entry as an underscore (_).
4.8.3 Editing values in a table
The meter has a feature, which allows the user to enter, edit or remove values in tables. (for example,
temperature and buffer values for a customized buffer group). This is accomplished by using the soft­
keys on the display to navigate from cell to cell.
1 Press READ to start editing the cell in the table.
The softkeys on the display change.
2 Press and
The softkeys change back to
3 Navigate to a cell and press Delete to remove a value.
4 To finish editing the table, navigate with the
5 Press READ to confirm the action and exit the menu.
4.9 Calibration
The meter allows you to perform calibrations with up to 5 points.
Calibration is only possible in the full-information screen. When starting a calibration by pressing the
CAL key while the instrument displays the close-up screen, it will automatically switch to the full-infor­
mation screen.
once.
to enter the value and press READ to confirm.
and
to move right, and
and press READ to delete the previously
.
and to highlight Save.
to
Operating the meter 17