Wiring Diagram - Fell Marine WiMea Boat Unit BU90115 Manual De Usuario

Wiring diagram

Close to stop
From WiMEA
Red
Boat Unit
Black
Gray
5-pin IP67
Blue
Connector
Orange
Open to stop
From WiMEA
Red
Boat Unit
Black
Gray
5-pin IP67
Blue
Connector
Orange
Diode kit for multiple engines
A
T O
S P L I T T E R *
W I M E A
B
*Engine manufacturer
splitter
28
Fuse
Battery
1 A
10 - 32 Vdc
From existing
kill switch cable
Close to stop
Fuse
Battery
1 A
10 - 32 Vdc
From existing
kill switch cable
Open to stop
A
B
M U L T I P L E
E N G I N E S
A
B
Multiple engine configuration
If you have more than one engine on your boat and your boat is
already fitted with a kill switch you can connect the wires as
described above to the two existing signal wires leading to the
existing mechanical switch in your helm or throttle. You may notice
that the existing wires consists of a splitter component (diode kit)
on the wires. This splitter must not be removed, as this splitter
translates the signal from the single mechanical kill switch into
a kill switch signal for multiple engines. You should connect the
WiMEA Boat Unit wires after this splitter, i.e. on the last two wires
leading into the existing mechanicatl switch installed in your helm.
If you have multiple engines and do not have an
NOTICE
existing kill switch, wires and a splitter must be
bought from your engine manufacturer or local
retailer. Please contact your local engine retailer
or manufacturer.
Installing WiMEA in a metal boat
If your helm is made out of conducting materials the wireless
signals from WiMEA may be degraded. The amount of signal
degradation experienced may vary from across boats and must be
tested for each case. Please visit FELL Support at
www.fellmarine.com/support for more information and wire
diagram for your specific engine brand.
29