Silvercrest STS 12 A1 Instrucciones De Uso página 26

Select a suitable mounting location for the appliance:
― The TV Simulator may not be directly visible from outdoors.
― The fl ickering generated by the TV simulator must be visible
on the walls and/or ceiling from outdoors.
― A power socket must be easily accessible.
― The TV Simulator must be installed such that it can be infl uenced
by the twilight. This means that the fall of light from outside must
be given! Take note that when wall mounted, the twilight sen-
sor 8 is very close to the wall which aff ects the fall of light.
― The TV Simulator may not be located near a window which
could be well lit from outdoors, such as on a busy street or
next to street lights.
― There should be no additional time-controlled light source in
the room, e.g. a night light.
Remove the stand 5 by bending it slightly apart and then pull
♦
the restraints out of the mountings.
Drill two holes with a spacing of about 45 mm. Use the stand 5
♦
to mark the holes: the spacing will thus be measured correctly.
The boreholes must be suitable for 8 mm wall plugs.
Insert the supplied plugs into the holes and screw the stand 5
♦
fi rmly down through the holes for wall mounting 7 using the
supplied screws.
Push the TV Simulator back onto the stand 5. Ensure that the
♦
two cross-shaped restraints engage correctly with the mountings.
STS 12 A1
GB
MT
23