Replace Spark Plug - Poulan Pro PR 2322 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

CHECK FOR DAMAGED OR WORN PARTS

Contact an authorized service dealer for replacement of

damaged or worn parts.

• ON/OFF Switch - Ensure ON/OFF switch functions

properly by moving the switch to the OFF position. Make

sure engine stops; then restart engine and continue.

• Fuel Tank - Do not use unit if fuel tank shows signs of

damage or leaks.

• Gearbox - Do not use if the gearbox shows signs of

damage or leaks. After 50 hours of use, we recommend

that your gearbox be serviced by an authorized service

dealer.

INSPECT AND CLEAN UNIT AND LABELS

• Before and after each use, inspect complete unit for

loose or damaged parts. After each use, clean the unit

and labels using a damp cloth with a mild detergent.

• Wipe off unit with a clean dry cloth.

CLEAN AIR FILTER

A dirty air filter decreases engine performance and

increases fuel consumption. Always clean after every 5

hours of operation.

1. Clean the cover and the area around it to keep debris

from falling into the carburetor chamber when the

cover is removed.

2. Remove parts as illustrated.

NOTE: Do not clean filter in gasoline or other

flammable solvent. Doing so can create a fire hazard

or produce harmful vapors.

3. Wash the filter in soap and water.

4. Allow filter to dry.

5. Add a few drops of oil to the filter; squeeze filter to

distribute oil.

6. Replace parts.

INSPECT MUFFLER AND SPARK ARRESTING

SCREEN

a WARNING: The muffler on this product

contains chemicals known to the State of

California to cause cancer.

As your unit is used, carbon deposits build up on the

muffler and spark arresting screen.

For normal homeowner use, however, the muffler and

spark arresting screen will not require any service. After

50 hours of use, we recommend that your muffler be

serviced or replaced by your authorized service dealer.

CARBURETOR IDLE SPEED ADJUSTMENT

a WARNING: Keep others away when making

idle speed adjustments. The blade will be

moving during most of this procedure. Wear

your protective equipment and observe

all safety precautions. When making

adjustments, use a screwdriver short

enough to keep your hands behind the

handguard and away from the blade. After

making adjustments, the blade must not

move at idle speed.

The carburetor has been carefully set at the factory.

Adjustments may be necessary if you notice any of the

following conditions:

• Engine will not idle when the throttle is released.

• The blade moves at idle.

Keep others away when making idle speed adjustments.

Make adjustments with the unit resting on a level surface

free of debris that can be caught in the hedge trimmer

blade. Serious injury to the operator and others can occur

if the carburetor is not properly adjusted. Keep all parts of

your body away from the blade and muffler.

To adjust idle speed:

Allow engine to idle. Adjust speed until engine runs

without blade moving (idle too fast) or engine stalling (idle

speed too slow).

• Turn idle speed screw (1) clockwise to increase engine

speed if engine stalls or dies.

• Turn idle speed screw (1) counterclockwise to decrease

engine speed if the blade moves at idle.

a WARNING: Recheck the idle speed after

each adjustment. The blade must not move

at idle speed to avoid serious injury to the

operator or others.

If you require further assistance or are unsure about

performing this procedure, contact an authorized service

dealer or call 1-800-487-5951.