Rocam Positioning; Monitor Unit With Touchscreen - Rothenberger ROCAM 4 Instrucciones De Uso

 Guide the camera head (1) into the pipe system and carefully push it with the cable (4). Cau-
tion: Unwinding the reel too quickly may cause it to continue to spin.
 For optimal results, a camera head (SL40) with a stronger light yield up to DN300 can be
screwed on. Camera heads are interchangeable.
Do not pull the cable (4) over sharp edges, and do not bend it!! Check the camera
cable before each use for damage!
While it is being pushed, the cable (4) may loop: Breakage may result!!
During advancement through several pipe bends, the camera image is always upright.
 After work is finished, pull the cable (4) out of the pipe and push it directly onto the reel (8).
Remove coarse dirt and water with a rag while winding cable on reel.
 Clean thoroughly (see section 4.).
 Dismantle camera head (1) and accessories, plug cap and insert bending spring (3) with rell
cable (4) into the reel (8).
 Camera head (1) and accessories should be cleaned and safely stored.
 Close the flap.
Camera head and accessories must be cleaned after each use, dismantled and
stored safely. Abnormal transport of the camera head can cause damage!
 Check the camera head regularly the camera head (1) for leaks. For this purpose, screw the
test adaptor on the camera head, applying a maximum pressure of 1 bar by an air pump
with pressure indicator. If this test indicates a drop in pressure, replace camera head.
3.6

ROCAM positioning

A B C
The 33 kHz measuring system can penetrate masonry, stone, wood and plastic.
The intensity of the signal changes depending on the position and distance from the receiver.
3.7

Monitor unit with touchscreen

The grey, cylinder-shaped positioning probe (B) can be
screwed by hand between the camera head (C) and the
bending spring (A). Only finger tight, to avoid damaging
threads!
The positioning probe emits magnetic fields that are re-
ceived by the positioning receiver and are transformed
visually and audibly.
The ROCAM 4 comes with a 4GB SD card to save photo's and video's.
This can be removed for data transfer.
Connections Micro-HDMI, mini USB and SD card are on the side of the
monitor unit.
Only use a screened USB cable to make a connection between ROCAM
4 and a computer!
ENGLISH 29