Bosch SHE6AP02UC/03 Manual De Instrucciones página 24

Problem
Dishes are not getting dry enough
24
Odor
Dishwasher not filling with water
Water Leaks
Cause
1. Rinse agent dispenser is empty. (Rinse
agent indicator is activated).
2. Improper loading of dishes.
3. Selected cycle does not include drying.
Note: Plastic or Teflon do not typically dry
as completely as other items due to their
inherent properties.
Tub stains
1. Food debris is present at the bottom of
the dishwasher.
2. Food particles are present near the
door seal.
3. Dishes left too long in unit before run-
ning a cycle.
4. Residual water is present at the bot-
tom of the dishwasher.
5. Drain hose is obstructed.
1. Restriction in the water supply system.
2. Previous wash cycle was not com-
pleted.
3. Delay-start is active.
1. Suds
2. Door seal could be pulled away from
track.
3. Condensation vent is blocked.
4. Improper installation.
1. Stains on the dishwasher interior are
due to hardness of water.
2. Silverware in contact with tub.
Action
1. Add rinse agent. The use of rinse agent im-
proves drying.
2. Rearrange load to ensure items are not
nested. Refer also to the "Preparing and Load-
ing" section of this manual.
3. Rinse and Hold setting does not include dry-
ing cycle,
Note: Select models offer on extra heating op-
tions to improve drying performance. Refer to
"Wash Cycle options" under the Operating the
Dishwasher section of this manuel.
1. Remove the filters and clean according to the
"ChecklClean the Filter System" section of this
manual.
2. Refer to "Clean the Door Gasket and Door
Seal" in the Care and Maintenance section of
this manual.
3. Run a Rinse/Hold cycle if you do not intend to
immediately wash the dishes.
4. Ensure the unit has completely drained from
the last cycle. Refer to the "Canceling or
changing the cycle" section of this manual.
5. Remove any obstructions from the drain hose
by calling qualified personnel.
Note: If odor still persists, run the Normal/Regular
cycle until it flushes and interrupt the cycle and
place on 8 oz. cup of distilled white vinegar solu-
tion on the top rock end then finish the cycle.
1. Ensure that the water supply valve (typically
located under kitchen sink) is open and check
that the water supply line has no kinks and
clogs.
2. Refer to the "Canceling or changing the cycle"
section of this manual.
3. Cancel the delay-start or wait until delay-
start time completes (times out). Refer to the
"Delay Start" section of this manual.
1. Wrong type of detergent results in suds and
leaks. Use only dishwasher detergents. If
suds still persist, then add one tablespoon of
vegetable oil at the bottom of the dishwasher
and run the desired cycle.
2. Ensure that door seal is in the track.
3. Ensure that condensation vent is not blocked.
Refer to "Loading Extra Tall Items" in the Pre-
paring and Loading the Dishwasher section
of this manual.
4. Have proper installation verified by qualified
personnel (water supply, drain system, level-
ing, plumbing).
1. Concentrated Lemon juice can reduce the
build up of hard water stains. Run a normal
cycle until it flushes and interrupt the cycle
and then place an 8 oz. cup of the concen-
trated lemon solution on the top rack and
finish the cycle. This can be done periodically
to avoid build up.
2. Ensure that the silverware does not make
contact with the tub while running a cycle.