TFA 60.5013 Instrucciones De Uso página 11

TFA_No. 60.5013_Anleit_03_19
Radio-controlled projection clock with thermometer
• To activate or deactivate the alarm function press the ALARM button.
+ or no alarm symbol is shown on the LCD.
• Once the alarm starts to ring, you can stop the alarm by pressing the ALARM
button.
• You can activate the snooze function by pressing the SNOOZE/LIGHT button on
the top.
• Zz appears and the alarm will be interrupted for 4 minutes.
7.6 Dual time setting
• Press the MODE button three times in the normal mode.
• DUAL TIME and 0:00 appear on the display.
• Hold the MODE button for 2 seconds. The hour digits are flashing.
• Press the UP or DOWN button to adjust the hours.
• Confirm with the MODE button and set minutes in the same way.
• Confirm with the MODE button.
7.7 Projection and light
A. For permanent projection connect the power adapter and slide the CONTINUE
PROJECTION switch upwards.
• Press the TEMP/FLIP button to turn the image by 180°.
• Turn the dial and set the focus.
• Hold the TEMP/FLIP button for three seconds and the projection toggles
between time and temperature every 5 seconds.
• Hold the TEMP/FLIP button for three seconds to deactivate the toggle.
B. Without permanent projection (CONTINUE PROJECTION off)
• Press the SNOOZE/LIGHT sensor button.
• The backlight will be activated and the projection will turn on for a few seconds.
Note: To avoid interference, the backlight and the projection turn off during the
reception of the radio controlled clock signal.
20
18.03.2019 11:13 Uhr Seite 11
,
Radio-controlled projection clock with thermometer
7.8 Charging function
,
• Attention: The charging function only works with the power adapter.
• Plug the USB cable (not included) into the USB port on the alarm clock and
connect the other end to your mobile device. Make sure that the USB charg-
ing function is suitable for your mobile device (charging current 500 mA).
• Do not apply excessive force when connecting the USB plug. A USB plug fits
only one way into the USB port.
8. Care and maintenance
• Clean the instrument with a soft damp cloth. Do not use solvents or scouring
agents. Protect it from moisture.
• Remove the batteries and pull out the plug of the socket, if you do not intend
to use the product for a long period of time.
• Keep the device in a dry place.
9. Troubleshooting
Problems
No display
No permanent projection
No DCF reception
Solution
Operation with power adapter:
➜ Connect the device to the power adapter
➜ Check the power adapter
Battery operation:
➜ Ensure the batteries' polarity are correct
➜ Change the batteries
➜ Connect the device to the power adapter
➜ Slide the switch CONTINUE PROJECTION in
direction of the arrow
➜ Wait for the DCF signal reception
➜ Press and hold °C / °F / WAVE button for two
seconds to activate the reception
21