How To Use The Remote Control - Num'axes Canicom Spray Manual De Instrucciones

• Reset of the spray counter on the remote control
To reset the spray counter after having refilled the collar tank, proceed as follows:
− Activate the remote control.
− Select the collar for which you want to reset the counter by briefly pressing the 0 button of the
remote control (the number 1 or 2 appears on the LCD screen).
− Press and hold the 0 button (for minimum 5 consecutive seconds) until the tank symbol on
the LCD screen is full.
Diagram 8
Reset the spray
counter

How to use the remote control

●
The Canicom Spray remote control is designed to operate with 1 or 2 receiver collars.
• 0 button: dog selection / reset of the spray counter
Before sending any training instruction (beep sound, vibration or spray), you have to select the
dog you want to send a message to. In order to select the dog, briefly press the 0 button of the
remote control (the number 1 or 2 appears on the LCD screen).
The 0 button is also used to reset the spray counter (see § Reset the spray counter on the
remote control).
• button: beep sound
If you press the button, the receiver collar will emit beep sounds. The collar will continue to
beep for as long as the button is pressed.
With the beep sound you can:
− send a warning to your dog when he is disobedient,
− draw his attention...
It's very important to always use the beep sounds in the same way in order not to
disturb your dog.
• V button: vibrations
If you press the V button, the receiver collar will emit vibrations. The collar will continue to vibrate
for as long as the button is pressed but no more than 8 seconds maximum.
If you press the V button for more than 8 seconds, the collar will automatically go into safety
mode for a few seconds before restarting itself normally.
Gb - 23
Empty tank
collar 1
Full tank
collar 1