Bodum BISTRO 11547 Instrucciones De Uso página 10

spEcial saFEtY
inForMation
bEForE You
usE Your
WaFFlE MaKEr
Double-check to make sure that the voltage rating on the
identification label of the device is congruent with the mains
voltage of your specific region. Plug the device only into a
properly grounded socket with an output rating of at least 6A
(if you are using a fault protection switch plate (rCD), please
ask an electrician for advice). While the device is in operation,
the socket must be easily accessible in the event of an emer-
gency. the manufacturer shall not assume any liability for
accidents resulting from deficient or non-existing grounding.
if the socket should not be compatible with the plug of your
appliance, please have the socket replaced by a certified
electrician.
Do not use any metal parts, knives, forks or similar objects to
place waffle batter into the Waffle Maker or to remove them.
this could damage the anti-stick coating. Always use plastic
or wooden spoons/tools.
An extension cord can be used with this device provided the
applicable precautions are taken.
if you are planning to use an extension cord, make sure
that the electrical indices of the extension cord are at least
the same as those of the device. if the device is grounded,
the extension cord must be three-prong and grounded. the
longer cord must be positioned in such a manner that it does
not hang down over the edge of a table or of a work surface.
Also make sure that children cannot pull on it and that it
does not create a stumbling/tripping hazard unintentionally.
before its first use, make sure you clean the device. see
chapter MAiNtENANCE AND CArE.
Distribute some cooking oil over the waffle iron surfaces.
Allow the device to heat up in setting «5» for 5 minutes while
it is empty and the cover is open. Next, turn the temperature
control down to setting «i», unplug it and wait until the appli-
ance has cooled down.
You may detect a slight odor in the air when the device is
heating up the first time. this is a normal occurrence when
the components are heated up for the first time.
the appliance is not to be operated in the open position.
8
EN