Amplicomms RingFlash 250 Manual De Instrucciones página 23

In some cases where the amplicomms Ring
Flash is used in conjunction with older phones
or those phones that do not comply to Euro-
pean Standard ES 203021 connectivity, either
the RingFlash or telephone may not function
correctly. If this happens you may notice the
possible to hear dial tone in the receiver when
the telephone handset is lifted. To resolve this
please retain your existing telephone line cord
with your phone and use a double adaptor in
the telephone socket (not supplied). Plug the
telephone into one side of the double adaptor
then plug your Ring Flash into the other avail-
able socket on the adaptor.
1. Disconnect the existing telephone con-
nection line from the phone currently
used.
2. Connect the end of the telephone cable
just disconnected in the telephone line
port LINE (10) in the RingFlash 250 base
station.
Using the RingFlash 250
3. Then plug the telephone line supplied in
your telephone.
4. Connect the other end of the telephone
cable to the telephone connection port
TEL (12) in the RingFlash 250 base stati-
on.
5. Now connect the power adapter plug sup-
plied to the power outlet.
6. Plug the cylindrical plug on the power
adapter plug in the connection port for the
adapter plug (11) in the RingFlash 250
base station.
As soon as the RingFlash 250 base
station is connected to the power supply
network, the RingFlash 250 base stati-
on issues an acoustic signal to indicate
correct installation. If there is no acoustic
signal, disconnect the power adapter
plug from the power socket. Check the
connections on the RingFlash 250 base
station. Wait for 1 minute and plug the
power adapter back in the power socket.
23