NOTES:
Please note the label of the relevant item of clothing to ensure that it is suitable for cleaning with vapour. If you are not
sure, test the cleaner first in a location on the inside of the item of clothing and ensure that the material is not damaged
by the cleaning.
NOTE: Never pull too much on the telescope hose. This may result in vapour coming out.
NOTE: RISK OF SCALDING
Never touch the window / textile cleaning fixture or the washing vapourisation cloth during use. The corresponding parts
get extremely hot. Hold the telescope hose away from your body and avoid touching the hose. It also gets very hot.
6.
If the hand vapour cleaner stops releasing vapour, switch it off and disconnect the mains adapter. Fill the water
tank and continue cleaning.
7.
If you are finished cleaning, let the textile cleaner cool off and remove it from the fixture. In doing so, proceed
carefully, as the textile cleaner may still be hot.
DUST FIXTURE
NOTE: Ensure that the device is unplugged.
1.
Fill the water tank with water (see Section: Using the UV MOP)
2.
Apply the microfibre dust cloth on the dust fixture and place it on the telescope hose (see Section: Putting the
further accessories together).
3.
Switch the device on and adjust the vapour control (see Section: Using the hand vapour cleaner - from Item 2)
NOTE: Never use the strongest settings on the vapour control if you are using the dust fixture. You can adjust the
vapour output at any time during use with the vapour control.
4.
Hold the hand vapour cleaner in one hand and take the handle of the telescope hose in the other hand (Figure 20).
5.
Move the cleaner slowly over the surface to be cleaned. The suction microfibre dust cloth absorbs the dirt that
was loosened by the vapour cleaner. Prepare a cloth in order to brush off excess water that may occur.
NOTE: Never pull too much on the telescope hose. This may result in vapour coming out.
NOTE: RISK OF SCALDING
Never touch the dust fixture or the microfiber dust cloth during use. The corresponding parts get extremely hot. Hold the
telescope hose away from your body and avoid touching the hose. It also gets very hot.
6.
If the hand vapour cleaner stops releasing vapour, switch it off and disconnect the mains adapter. Fill the water
tank and continue cleaning.
7.
If you are finished cleaning, let the microfibre cloth cool off and remove it from the fixture. In doing so, proceed
carefully, as the cloth may still be hot.
After use
1.
Disconnect the mains adapter from the socket.
2.
Let the device or the relevant fixture used cool off and remove it cautiously, as it may still be hot.
3.
Always empty the water tank after use and before stowing away the device.
4.
Let any condensation water run out of the vapour outlet before you stow away the device.
5.
Wind mains cable around the top and bottom winding.
6.
Use a soft cloth to clean the surface of the UV MOP .
7.
If you do not need the device, stow it away in a dry and cool place. Do not leave it exposed to the sun or rain.
8.
Standing storage of the UV MOP with applied cleaning cloths may result in white stains on your floor. For that
reason, always remove the cleaning cloth from your mop before you stow it away.
22