Speck Badu Jet IMPERIAL Manual De Instalación página 15

Jet Housing Installation - Liner and/or Fiberglass Pool Construction - continued
6. Align the stainless steel handles (part #70) over the
clamping ring gasket.
7. Align the clamping ring (part #28) over the stainless
steel handles (part #70) as shown in Figure 7.
8. Install the twelve (12) M8 x 30 clamping ring screws
(part #52).
9. Follow steps 1-4 under Jet Housing Installation - New
Gunite or Concrete Construction on page 9-10.
10. Continue to Final Assembly Section on page 17.
NOTE: The gunite cover (part #30), M8 x 80 studs (part #31),
8.4mm washers (part #32), and M8 nuts (part #33) are used
in those cases where the swimming pool is commissioned
without the final assembly kit being installed.
CAUTION: All screws should be HAND TIGHT. DO NOT use
drills or pneumatic tools. DO NOT over tighten!
Figure 13
Fiberglass Pool Installation
Figure 14
Liner Pool Installation
Fiberglass pool
1
26
Liner pool
1
26
14.0"
Figure 12
Template for fiberglass/vinyl liner pools
27
70
98
27
70
98
WATER LEVEL
1)
13.3"
15°
1) Fasten to clamp ring (12x)
28
52
28
52
0.35"
15