Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
shown in Fig. 11 and then tighten the screw.
Use commercially available AAAA batteries
(1.5 V).
NOTE:
Do not tighten the screw excessively. Such action
could strip the screw threads.
CAUTION:
Failure to observe the following can result in
battery leakage, rust or malfunction.
Position the plus (+) and minus (-) terminals
correctly.
Replace both batteries at the same time. Do not
mix old and new batteries.
Remove exhausted batteries from the hook
immediately.
Do not discard batteries together with normal
trash and do not throw batteries into fire.
Store batteries out of the reach of children.
Use batteries correctly in accordance with the
battery specifications and indications.
2. Installing the bit
Always follow the following procedure to install
driver bit. (Fig. 13)
(1) Pull the guide sleeve forward.
(2) Insert the bit into the hexagonal hole in the anvil.
(3) Release the guide sleeve and it returns to its
origianl position.
CAUTION
If the guide sleeve does not return to its original
position, then the bit is not installed properly.
3. Removing the bit
Please do the opposite point on the method of
installing bit.
4. Confirm that the battery is mounted correctly.
5. Check the rotational direction
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the push button.
The L-side of the push button is pushed to turn
the bit counterclockwise. (See Fig. 14). (The
marks are engraved on the body.)
R
CAUTION
The push button can not be switched while the impact driver is turning. To switch the
push button, stop the impact driver, then set the push button.
16
Inden-
tation
AAAA
batteries
Driver
Hexagonal
bit
hole in the
anvil
R
Push
and
L
Arrow
Hook cover
Fig. 11
Hook main body
Hook cover
Indentation
Fig. 12
Movement
Guide
sleeve
Fig. 13
Push
button
Push
Fig. 14
Protube-
rance
Protube-
rance
L
Tabla de contenido
