Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
Driving and removing of small screws, small bolts, etc.
REMOVAL AND INSTALLATION METHOD OF BATTERY
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks
in place with a little click, If not, it may
accidentally fall out of the tool, causing
injury to you or someone around you.
(Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle
while pressing the latch of the battery.
(Fig. 3)
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
12
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
Handle
Battery
Do not use the electrical cord if damaged. Have it
repaired immediately.
Insert
Pull out
Latch
Fig. 3
Tabla de contenido
