Changing Programs; Changing Volume - Advanced Bionics NEPTUNE Manual De Uso

Changing Programs

The program switch is located on your Neptune Connect to allow you to easily
change your program position prior to, or during, use. The sound processor can store
up to three programs for optimal listening in a variety of situations. These programs
can be updated and changed by your clinician during fi tting.
To change programs:
1.
Slide the program switch located on the front face of the Neptune Connect to the
desired program position.
2.
You may need to sync the Neptune Connect with the sound processor prior to
changing the program. For more information, refer to the 'Sync Light' section of
the User Guide.
3.
For instructions on use of the monitor (Δ) switch position, refer to the 'Listening to
the Microphone and FM Receiver' section of the User Guide.

Changing Volume

decrease
Volume
Volume changes are managed differently depending on whether the Neptune
Connect has remained on the sound processor or has been disconnected during use.
If the Neptune Connect has remained attached to the sound processor during use,
changes take effect immediately. If the Neptune Connect has been removed and
the settings changed, the processor and Neptune Connect should be synced before
volume changes will take effect. For more information, refer to the 'Sync Light'
section of the User Guide.
monitor
P1 P2 P3
increase
Sensitivity
User Guide for the Neptune™ Sound Processor 25