Switching Off; Error Messages - BOMANN EKI 551 CB Instrucciones De Servicio

NOTE:
• The end of the cooking time is indicated when the time
has elapsed by means of a buzzer.
• Delete the time: If you would like to delete the preset
times, press the TIMER CANCEL (2) button, so that the
control lamp goes off.
• Automatic shut-off: the hot plate turns off automatically
after 120 minutes, if no input was given over the operator
control panel during this time. This switching serves as
security for you.
• With the „KEEP WARM" function you can keep the meals
you have prepared warm. For this you should press the
button (7) once during the cooking process. The tempe-
rature is preset to 70°C. To switch this off, press the ON/
OFF button (6).

Switching off

• Push the ON/OFF button (6).
• The hob changes back to the standby mode from whatever
operating mode. The operating mode indication (5) fl ashes.
• Pull the plug.
• Let the device cool down, before you put it away.
The device has a pot recognition function. After the pot has
been taken from the hob, it switches back to the standby mode.
In this context, please pay attention to the following:
WARNING:
• After use, the hob must be switched off using the provided
controls – not over its automatic pot recognition function
only!
• Hazard of burns! Because of the heat radiated during
cooking, dangerously high temperatures may occur at the
cooking zone after the cooking cycle.
• Always pull out the plug from the mains socket before
cleaning and wait until the unit has cooled down.
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Under no circumstances should the device be immersed in
water for cleaning.
Ceramic Hob
• Clean the surface from food remains when it's still warm
using a moist cloth or tissue.
• Wash the hob using a soft sponge and some water, then
wipe dry with a soft cloth.
• Cleaning agent for glass-ceramics surfaces: In case of
stubborn, baked-in remains, use suitable cleaning products
available at special departments of department stores.
34
05-EKI 551 CB.indd 34 05-EKI 551 CB.indd 34
Cleaning
Housing
• Clean the housing after use using a slightly moist cloth.
• Make sure that no fl uid matter gets into any of the openings
of the housing. This might damage the device or result in an
electric shock.
Troubleshooting
• Device does not function, no indication on the display.
Remedy:
Check the mains connection
• There is a sound after I have selected a cooking
function and switched the device on.
Possible cause:
You put no or an unsuitable pot on the hob.
NOTE:
For reasons of safety, the device automatically switches to
the standby mode after a few seconds.
Remedy:
Put a pot on the hob that is suitable for induction hobs.
• The hob suddenly switches off during operation.
Possible cause:
The overheating protection (cutout switch) has been
activated.
Remedy:
Pull the plug and let the device cool down for about 20 min.
Then start operating the device again.
Further cause:
The ventilation slots are obstructed.
Remedy:
Free the ventilation slots from any obstructions.
• When keeping food warm the pot is not maintaining the
temperature.
Possible cause:
The pot's base is not level or bended (convex/concave).
Remedy:
Put a suitable pot on the hob.
•

Error messages

During the operation the display shows the following security
instructions:
Security
instruction
E1 o. E2 In this case, there is a problem with the
electronic control.
E3 o. E4 Overheating. See below remedy of the fault.
E5 Undervoltage. Check the power supply
system!
E6 Overvoltage. Check the power supply system!
25.08.2008 9:46:20 Uhr 25.08.2008 9:46:20 Uhr