Preparation For Use - Unpacking; Overload Indication - Wavetek Meterman HD160B Manual De Instrucciones

8,000 V). Refer to your CRT service manual for proper servicing instructions.
Your shipping carton should include the multimeter, a holster with flex strap, one
test lead set (one black, one red), one 9V battery (installed), one spare fuse, a hex
wrench (held inside holster) and this manual. If any of the items are damaged or
missing, immediately return the complete package to the place of purchase for an
exchange.
The holster/tilt stand provides additional protection of the meter from accidental
falls and provides greater ease of use. Both test lead probes can be attached to the
holster for storage. One probe can be attached for measurement, holding the
meter with probe in one hand and the second probe in the other hand.
while range is locked) is also indicated by "I.OL". Select the next higher range
until a value is displayed, or return to autoranging. If overload still exists in the
highest range, remove test leads from the measurement setup as input is beyond
the range of the meter.
Note: In both instances, overload indication is normal in the OHMS and continuity
ranges (no sound) when the leads are not connected to anything or when the
measured value is higher than the selected resistance range.
PREPARATION FOR USE – UNPACKING
PROTECTIVE HOLSTER

OVERLOAD INDICATION

Input Overload (highest range in autoranging) is
indicated by "I.OL" and a continuous tone. Remove
test leads from the measurement setup as the input
is beyond the range of the meter.
Display Overload (input exceeds the selected range
- 3 -