D - MAINTENANCE OF THE LEVPANO
1) General maintenance
Check the following parts at regular intervals, according to the indications given in the table below:
-
The condition of the cables, pulleys and pulley pins,
-
The condition of the rubber stops and shoes,
-
The condition of the tilting and pivoting locks
-
The conditions of the wheels and the operation of the
wheel brakes,
-
The fixing and clamping devices
-
The cleanness of the columns,
-
The condition of the winch and its function (see § 2)
-
The condition of the head and its function (see § 3)
And replace if necessary.
Any defective cable must be replaced by a guenuine cable.
Characteristics of the cables: diameter 3 mm, composition: 7 x 19 wires, actual breaking load: 5.75 kN
2) Maintenance of the winch :
The winch requires regular servicing by a competent department. Regular cleaning makes for a
longer service life.
- Never work with a defective cable.
- Keep the pinions, bearings and reel pin well greased. Use a Molydal N° 3790 type grease
-
Keep the winch in good operating condition. Non-serviced mechanical parts can cause operating
problems or even accidents.
3) Maintenance of the head :
The head requires cleaning at intervals.
Verify that there is sufficient play to make it possible for the discs to pivot to each other.
Make sure that the two pivoting discs are always correctly greased.
Use grease of the Molydal type, no. 3790
E – TROUBLESHOOTING GUIDE
If there is apparently a fault on the LEVPANO
to be repaired, taking all necessary safety precautions (wear a helmet, goggles and gloves).
If the device is locked in the raised position, make sure that the plasterboard panel is fixed at the
ceiling or secure this by means of supports, before attempting to unlock it.
PARTS
®
FREQUENCY
Week
Month
X
X
X
X
X
X
X
X
, go through the following points before asking for it
®
19
TYPE OF
VERIFICATION
Visual
Test
Lubrication
check
X
X
X
X
X
X
X
X
X
X
X
X
X
X
.
X
X