Cleaning And Maintenance; Noise Development; Technical Data; Guarantee - BOMANN SMS 349 CB Instrucciones De Servicio

Table
Food type Preparation
peeled,
Boiled eggs
diced (1/4 pieces)
Herbs
Walnuts/ha- without
zelnuts shells!
without
Almonds
shells!
Garlic peeled
Onions 2 cm pieces
washed,
Parsley
destalked
Bread
(bread 2 cm pieces
crumbs)
Meat 2 cm pieces
Parmesan
1 cm pieces
cheese
Of course, you can chop also other foods that are not specifi ed
herein. In order to determine the maximum time for a type of
food that is not specifi ed herein, compare it with the hardness of
another type of food provided in the table, i.e. an Apple has the
same insistence of onion. In this case, refer to the indications in
the table for „onion".
5. Seal the bowl again with the lid; the recesses on the lower
edge of the lid and on the upper edge of the bowl must
interlock.
6. Place the motor casing on the upper opening of the lid and
fasten the multi-chopper by turning it to the right.
7. Only connect the machine to a properly installed safety
socket, 230 V/50 Hz. Allow the multi-chopper to stand on the
surface during operation until you remove the multi-blade
(7). Hold the multi-chopper fi rmly with a hand.
8. Press one of the buttons on the two-level control switch.
You can achieve pulse operation by pressing the button at
intervals and then releasing it.
9. Remove the mains plug from the socket after use. Wait for
the blade to stop before removing the contents of the contai-
ner! Release the motor housing from the multiple chopping
machine by turning it and then remove it from the lid.
10. Remove the lid and pull the multi-blade out carefully.
WARNING:
The multi-blade is very sharp! DANGER OF INJURY!
11. Pour the contents of the beaker into a container or plate.
12. Clean the appliance as described in „Cleaning and Storage".
05-SMS 349 CB.indd 33 05-SMS 349 CB.indd 33
Maximum Maximum
Tool
Quantity Time
300g
10 sec.
Blade
15 sec.
150g Blade
or pulse
200g 15 sec. Blade
200g 15 sec. Blade
15 sec.
200g Blade
or pulse
15 sec.
250g Blade
or pulse
60g 10 sec. Blade
15 sec.
40g Blade
or pulse
15 sec.
250-400g Blade
or pulse
100g 15-20 sec Blade

Cleaning and Maintenance

• Always pull the plug out of the socket before cleaning!
• Twist the mixing rod or whisk off the motor housing and
rinse the part under running water. Then dry the mixing rod
or whisk off thoroughly.
• Removable parts which have come into contact with food
(tool and container) can be cleaned in soapy water. You
can add a commercially available washing-up liquid. Do not
immerse the device in water.
• Rub the outside of the motor casing with a moist towel to
clean it when necessary and then wipe it with a dry cloth.
• After cleaning, store the mixing rod in the accessory holder
supplied (see illustration D). Tighten the attachments and
the mixing rod with one clockwise turn to prevent the attach-
ments from falling down.

Noise development

The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 75.0 dB(A) (no limit)

Technical Data

Model: ....................................................................... SMS 349 CB
Power supply: ............................................................230 V, 50 Hz
Power consumption: ............................................................200 W
Protection class: .......................................................................... ΙΙ
Filling quantity: ..........................................................0,1 - 0,5 Litre
Net weight: ........................................................................... 1,1 kg
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!

Guarantee

The device supplied by our Company is covered by a 24 month
guarantee starting on the date of purchase (receipt).
During the life of the guarantee any fault of the device or its
accessories ascribable to material or manufacturing defects will
be eliminated free of charge by repairing or, at our discretion, by
replacing it. The guarantee services do not entail an extension
of the life of the guarantee nor do they give rise to any right to a
new guarantee!
Proof of the guarantee is provided by the proof of purchase.
Without proof of purchase no free replacement or repair will be
carried out.
If you wish to make a claim under the guarantee please return
the entire machine in the original packaging to your dealer
together with the receipt.
33
08.11.2007 15:07:33 Uhr 08.11.2007 15:07:33 Uhr