Load Label Roll In Peel Off Mode; Load Label Roll In Passing Mode - Carl Valentin SPX II Serie Instrucciones Abreviadas Y Recomendaciones De Seguridad

Load Label Roll in Peel off Mode

J
I
H
G
F E D

Load Label Roll in Passing Mode

E
D
C B A
C B A
English
•
Open the print module cover.
•
Open the printhead (I) by turning the red pressure lever (J)
anticlockwise.
•
Lead the label material (minimum height = 15 mm) below the
label guiding (A) and printhead (I) and take care that the
labels run through the photocell (C).
•
In order to move the printhead (I) down, turn the red pressure
lever (J) in clockwise direction until it locks.
•
Adjust the adjusting rings (B) of the label guiding to the width
of material.
•
Lift the dispensing whip (E) to the bottom by turning the stop
lever (G) in clockwise direction to the top.
•
Strip some labels from the backing paper and lead the
backing material over the dispensing whip (H) and between
the plastic roll (F) and the dispensing whip-shaft (D).
•
Press again the dispensing whip (D) to the top and lock it.
•
Lead the supporting paper to the back and fix it at a rewinding
unit.
•
Enter the offset value in the Dispenser I/O menu.
•
Close the print module cover.
•
Open the print module cover.
•
Open the printhead (D) by turning the red pressure lever
(E) anticlockwise.
•
Lead the label material below the label guiding (A) and
take care that the label runs through the photocell (C).
•
In order to move the printhead (D) down, turn the red
pressure lever (E) in clockwise direction until it locks.
•
Adjust the adjusting rings (B) of the label guiding to the
width of material.
•
Close the print module cover.
SPX II
117