Samsung DV42H5400 Serie Manual Del Usuario página 17

3-WZREsystem connections
1, Loosen or remove the center terminal block screw.
2. Connect the neutral wire (white or center wire) of the power cord to the center, silver-colored terminal screw
of the terminal block.Tighten the screw.
3. Connect the other wires to the outer terminal block screws. Tighten the screws.
4. Tighten the strain reEiefscrews.
5. Insert the tab of the terminaE block cover into your dryer's rear paneE slot.
6. Secure the cover with a holddown screw.
If converting from a 4-wire electrical system to a g-wire, the ground strap must be reconnected to the
terminal block support to ground the dryer frame to the neutral conductor.
4-WZREsgstem connections
1,
2.
3.
4,
S.
6.
7.
Remove the center terminal block screw.
Connect the ground wire (green or unwrapped) of the power cord to the external ground conductor screw.
Connect the neutral wire (white or center wire) of the power cord and the appliance ground wire (green with
yellow stripes) under the central screw of the terminal block.
Connect the other wires to the outer terminal block screws. Tighten the screws.
Tighten the strain relief screws.
Insert the tab of the terminal block cover into your dryer's rear panel slot.
Secure the cover with a holddown screw.
J f
i_ Externa ground connector i A ,--- _j_ .............
i B Greenorbarecopperwireofthepowercord l
t_
,h%i,Y %
_' B I
J_ 314 in. (1.9 cm) UL-listed strain relief j i --E
j_i Grounding wire(green/yellow) J ii _ I
J_ Neutral wire (white or center wire)
i
8. With a level, check your dryer and make the necessary adjustments to the leveling legs.
9. At this time, make sure all gas connections (on gas models), exhaust and electrical connections are complete.
Plug in your dryer, and check its operation by using the checklist below.
10. (GAS MODELS ONLY)
The burner may not ignite initially due to air in the gas line. AHowing your dryer to operate on a heat setting
will purge the line. If the gas does not ignite within 5 minutes, turn your dryer off and wait 5 minutes. Be sure
the gas supply to your dryer has been turned on. In order to confirm the gas ignition, check the exhaust for
heat.
English - 17