Initial Start-Up; Checking The Battery Pack And The Scope Of Delivery; Charging The Battery Pack; Use - ProCharger CP-10 Instrucciones De Montaje Y De Uso

5 | Initial start-up

5.1 | Checking the battery pack and the scope of delivery

1. Remove the battery pack from the packaging.
2. Check that the delivery is complete (see Fig. A).
3. Check whether the battery pack or the individual parts shows signs of any
damage. If this is the case, do not use the battery pack. Contact the manufacturer
at the specified service address.

5.2 | Charging the battery pack

The battery pack is supplied partially charged and has to be charged for up to 4
hours so that all the LEDs of the charge level indicator 8 light up constantly before
initial start-up. The battery pack should be charged completely after each use. It
does not reach its maximum capacity until it has been discharged/charged 3 times.
You can charge the battery pack in three different ways (see chapter 2 Fig. A):
Mains charger
1. Connect the coaxial power connector of the mains charger 10 to the mains plug
port 4.
2. Connect the mains plug of the mains charger to a properly installed power outlet.
Vehicle charger
1. Connect the vehicle charger 11 to the 12 V vehicle power outlet.
2. Connect the cable of the cigarette lighter plug to the mains plug port.
USB charger plug (not included in the scope of delivery)
1. Connect the micro USB cable of the charger adapter cable 13 to the micro USB port
3.
2. Connect the other end of the micro USB cable to a USB port on your computer or to
a USB charger plug.
3. Connect the USB charger plug to a properly installed power outlet.
The LEDs of the charge level indicator flash and indicate the charge status during the
charging process.
Once all the LEDs light up constantly, the battery pack is fully charged. The charging
cable then has to be disconnected from the mains power.
The battery pack cannot be charged while an electronic device is being
charged by the battery pack at the same time.
26
5.3 | Checking the charge status of the battery pack
The four LEDs of the charge level indicator 8 indicate the remaining charge level of
the battery pack. When you press the function key 1, the charge level is displayed
for a few seconds. While you are charging a device, the LEDs indicate the remaining
charge level of the battery pack.
Charge level Charge level indicator
100 % All four LEDs light up.
75 % Three LEDs light up.
50 % Two LEDs light up.
25 % One LED lights up.
<25 % One LED flashes.

6 | Use

6.1 | Charging devices using the USB port

1. Connect the charger adapter cable 13 to the USB port 5 (see Fig. C).
2. Connect the device you wish to charge to a suitable plug on the charger adapter
cable.
The charge level indicator 8 indicates the charge level of the battery pack.
3. On completion of the charging process, disconnect the device being charged from
the multi adapter.

6.2 | Charging laptops using the 19 V charging port

1. Connect the adapter cable of the 19 V charger adapter 12 to the 19 V charger port
2 (see Fig. D).
2. Select the appropriate adapter for your laptop and connect it to the adapter cable.
3. Connect the adapter to the charger port on you laptop.

6.3 | Using the jump start booster as a jump starter

WARNING!
Risk of fire electric shock and fire!
Incorrect use of the jump start cable increases the risk of electric
shock and fire.
• Always wear suitable work clothing, protective gloves and
protective goggles when you work on a vehicle battery.
27