Problem Solving - Philips SBC VL1405 Manual Del Usuario

10 ENGLISH
Problem
No picture on TV3
Bad picture/sound
quality on TV3
The cable
programme you
are watching
disappears after
several minutes
Wrong picture on
TV3
Wrong picture on
TV1

Problem solving

If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline
(see 'Need help?') or consult your dealer.
Never try to open the set yourself as this will void the guarantee.
First, check all cables to ensure that they are connected correctly.
Solution
• Ensure that both units are switched on (A-2 and B-20 are green).
• Select the EXT or AV channel on TV3.
• Activate the video source (set-top box: power on;VCR/DVD: playback).
• Select the correct video source on the Receiver unit.
• Select the same frequency channel on both the Receiver and
Transmitter units.
• If a VCR is the video source, ensure that the correct SCART connector
of the VCR is used (Ext1 or Ext2 - check VCRs user manual).
• Move the receiver unit around gently until you get good picture and
sound quality.
• Move the transmitter unit around gently until you get good picture and
sound quality.
• Change both units to another frequency channel.
• Reduce the distance between the transmitter and receiver unit (<30m).
• Disable the auto standby mode of the VCR. (Check VCR's User Manual).
• Select the EXT or AV channel on TV3.
• Select another video source on the receiver unit.
• Activate the video source (set-top box: power on;VCR/DVD: playback).
• Swap the SCART connectors on the transmitter unit.
• Switch to another frequency channel on both units.
• Select the correct EXT or AV channel on TV1
(see TV instruction manual).
• Select the correct video source with the VIEW SOURCE button (A-5).
• Select a regular programme number.