Bosch GHO 31-82 Instrucciones De Servicio página 15

Continuing interrupted planing
The integrated blade protector 31 also allows for
continued planing at any given location on the
workpiece after an interruption:
– With the blade protector folded down, place
the machine on the location of the workpiece
where the planing is to be continued.
– Switch the machine on.
– Apply the supporting pressure onto the front
part of the planer shoe and slowly push the
machine forwards ( ). This tilts the blade pro-
tector 31 up ( ) so that the rear part of the
planer shoe 13 faces on the workpiece again.
– Guide the machine alongside the surface to be
planed ( ) with an even feed.
Beveling Edges
The V-grooves 14 in the front planer shoe 13 al-
low quick and easy beveling of workpiece edges.
Depending on required bevel width, use the cor-
responding V-groove.
For this, place the planer with the V-groove 14
onto the edge of the workpiece and guide along
the edge.
15 • 2 609 932 112 • TMS • 19.10.01
Using the Parallel/Angle Guide
(Accessory)
Mount parallel guide 15 or angle guide 19 to the
machine using fastening bolt 16 and rebating
depth stop 2 using fastening bolt 1.
Loosen locking nut 17 and adjust the required re-
bating width with the scale 18. Retighten locking
nut 17 again.
Adjust the required rebating depth accordingly
with the rebating depth stop 2.
Carry out the planing procedure several times,
until the required rebating depth is reached. Pay
attention that the planer is guided with sideward
supporting pressure.
Beveling (only angle guide 19)
When beveling rebates and surfaces, adjust the
required slope angle with the angle adjust-
ment 20.
14
45°
The planer can be equipped with various planer
blades
tory-equipped with carbide blades.
When replacing a blade, always replace both
blades at the same time. Otherwise imbalance
can cause vibrations and reduce the service life
of the machine.
English - 4
24mm
max
Replacing the Planer Blade
Before any work on the machine itself, pull
the mains plug.
Be cautious when replacing the planer
blades: Possible danger of injury due to the
sharp cutting edges of the planer blades!
Do not grasp the planer blades by the cut-
ting edges.
Use only original Bosch HM /TC planer
blades.
(see accessories). It comes fac-