Tool Assembly - Milwaukee 6390 Manual Del Operador

To reduce the risk of injury, always unplug
tool before attaching or removing accessories
or making adjustments. Use only specifically
recommended accessories. Others may be
hazardous.
Removing and Replacing Positive-Lok
Cat. No. 6394
MILWAUKEE'S exclusive Positive-Lok
placement or substitution. The Positive-Lok
firmly to the tool.
Fig. 1
1
1. To remove the Positive-Lok
direction shown and turn the cord nut 1/4 turn to the left. Pull the
cord out.
2. To replace the Positive-Lok
push the connector in as far as it will go. Turn the cord nut 1/4 turn to
the right to lock. The cord release button will click back into place.
Selecting Blade
Always use sharp blades. Dull blades tend to overload the tool and
increase the chance of KICKBACK (see page 8). Only use blades with a
maximum safe operating speed greater than the no load RPM marked on
the tool's nameplate. Read the blade manufacturer's instructions before
use.
Installing and Removing Blades (Fig. 2 & 3)
1. Unplug tool before installing or removing blades.
2. Place the saw on a flat surface with the blade facing upwards. To
remove the bolt from the spindle, push in the spindle lock button. While
holding the spindle lock button in, use the wrench provided with the
tool to turn the bolt counterclockwise (Fig. 2). Remove the bolt and
blade flange.
Fig. 2
3. Slide the lower guard lever up to raise the lower guard. Remove the
blade from the spindle. Always clean the spindle, upper guard and
lower guard to remove any dirt and sawdust.
page 6
WARNING!
®
Cords (Fig. 1)
® Cords provide instant field re-
® feature secures the cord
2
Cord release button
®
Cord, push the cord release button in the
® Cord, align the connector keyways and

TOOL ASSEMBLY

4. To install a blade, place the blade on the spindle with the teeth pointing
in the same direction as the arrow on the lower guard (Fig. 3). Re-
lease the lower guard lever.
5. Place the blade flange on the spindle and hand tighten the bolt.
6. While holding the spindle lock button in, use the wrench to turn the bolt
clockwise and tighten.
Adjusting Depth (Fig. 4 & 5)
1. Unplug tool.
2. To adjust the depth of the cut, hold the saw by the Tilt-Lok™ handle
and loosen the depth adjusting lever by lifting it up and away from the
shoe (Fig. 4).
Fig. 4
3. Raise or lower the shoe to the desired position. Markings in 1/4"
increments are located on the inner side of the upper guard for depth
setting. For the proper depth setting, the blade should extend no more
than 1/4" below the material being cut (Fig. 5).
4. Move the depth adjusting lever towards the shoe and push down to
secure the position.
Fig. 3