Rain Soft Ultrefiner II Serie Manual De Uso página 8

2. Mount the System
Use screws (not supplied) to secure the Ultrefiner II bracket assembly to the
Figure 6
Figure 7
4.7 in (11.9 cm) without cover
5.0 in (12.7 cm) with cover
7.0 in (17.8 cm) Mimimum required
from mounted wall for cover on / off
3. Push-IN Tubing Connections:
F or all tubing connections on the system, follow these steps to be sure that
the tube is properly installed in the fitting:
•Slightly lubricate the tube with silicone before pushing into the fitting.
•It is important that the tube be fully inserted to the proper depth. You may
measure from the end of the tube & use a marker to put a line as a guide.
•See figure 8 for proper installation practice & depth on each connection.
8
USING PHILIPS OFFSET
SCREWDRIVER
TO SECURE THE ULTREFINER II
12.3 in (31.3 cm)
12.5 in (31.8 cm) with Cover
Helpful Tip: The proper drill bit should be selected
according to the type of material at the desired
installation location.
15.1 in (38.4 cm)
10.0 in (25.4 cm)
Important Note: Ultrefiner II tank port and
!
outlet port use double o-rings. If you see a leak
from one of these ports, remove the tube and
look into the port to see that both o-rings are
properly aligned, leaving a clear path for the
tubing. If one of the o-rings is moved out of posi-
tion, it may block tube insertion. Please push it
back into position before inserting the tube.