Tabla de contenido
Idiomas disponibles
Idiomas disponibles
installing your washer
Flooring
For best performance, your Washer must be installed on a solidly constructed floor. Wood floors
may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting
and soft tile surfaces are contributing factors in vibration may cause your washer to move slightly
during the spin cycle.
Never install your washer on a platform or weakly supported structure.
Location considerations
Do not install your washer in areas where water may freeze, since your washer will always
maintain some water in its water valve, pump, and hose areas. This can cause damage to the
pump, hoses and other components.
Alcove or closet installation
MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides – 1 in / 25 mm
Rear – 5.9 in / 150 mm
If the washer and dryer are installed together, the closet front must have at least a 72 in² (465
cm²) unobstructed air opening. Your washer alone does not require a specific air opening.
A
1 in.
(2.5 cm)
A. Recessed area
B. Side view - closet or confined area
Undercounter installation(washer only)
18_ installing your washer
WF455AG-03159A-03_EN.indd Sec3:18
WF455AG-03159A-03_EN.indd Sec3:18
1 in.
(2.5 cm)
27 in.
27 in.
(68.6 cm)
(68.6 cm)
39.6 in.
(100.6 cm)
1 in.
(2.5 cm)
Top – 17 in / 432 mm
Closet Front – 2 in / 51 mm
B
1 in.
2 in.
34.1 in.
(2.5 cm)
(5 cm)
(86.5 cm)
27 in.
1 in.
(68.6 cm)
(2.5 cm)
17 in.
(43.2 cm)
5.9 in.
(15 cm)
2012-08-31
2012-08-31
12:31:50
12:31:50
Capítulos
Tabla de contenido
